Most commonly referred to as a “Wild Leg”
system. (3 phase 4 wire) 240 volts is available
between phases and 120 volts is available
between two of the phases and the neutral
which is grounded (usually the A and C phases).
It should be noted that between the B phase and
ground 208 volts is available.
Subscribe:
Popular Posts
-
The drive is coupled to e. g. a CU320 multi-axis Control Unit through the CU Adapter CUA31 via a DRIVE-CLiQ interface. In this collection...
-
The motor constant makes it possible to design the nominal point of DC motors corresponding to the process requirements. However the effic...
-
A box for the distribution of electrical current located either inside or outside the house which connects to the service entrance conduct...
-
A test used to measure an insulation system’s resistance. This is usually measured in megohms and tested by passing a high voltage at low...
-
A method of reversing motor rotation by the use of two separate contactors, one of which produces rotation in one direction and the other ...
-
The historical development of the DC motor as an electric variable-speed drive since the beginning of the twenties has meant that DC motor...
-
Efficiency Ratio of mechanical output to electrical input indicated by a percent. In motors, it is the effectiveness with which a motor c...
-
It is also possible to use SINAMICS S120 AC Drives in multi-axis applications. The drive is connected to a CU320 Control Unit via the DRIV...
-
Currents induced in motor components from the movement of magnetic fields. Eddy currents produce waste heat and are minimized by laminati...
-
IGBTs (insulated gate bipolar transistor) provide a high switching speed necessary for PWM inverter operation. IGBTs are capable of switc...
0 comments:
Post a Comment