Very common system in large industrial
applications. This (3 phase 3 wire) system is
usually installed ungrounded and requires
maintenance by “qualified persons”. Electrical
equipment installed on this system must be
rated 480V phase to ground as well as phase to
phase.
Subscribe:
Popular Posts
-
The drive is coupled to e. g. a CU320 multi-axis Control Unit through the CU Adapter CUA31 via a DRIVE-CLiQ interface. In this collection...
-
The motor constant makes it possible to design the nominal point of DC motors corresponding to the process requirements. However the effic...
-
A box for the distribution of electrical current located either inside or outside the house which connects to the service entrance conduct...
-
A test used to measure an insulation system’s resistance. This is usually measured in megohms and tested by passing a high voltage at low...
-
A method of reversing motor rotation by the use of two separate contactors, one of which produces rotation in one direction and the other ...
-
The historical development of the DC motor as an electric variable-speed drive since the beginning of the twenties has meant that DC motor...
-
Efficiency Ratio of mechanical output to electrical input indicated by a percent. In motors, it is the effectiveness with which a motor c...
-
It is also possible to use SINAMICS S120 AC Drives in multi-axis applications. The drive is connected to a CU320 Control Unit via the DRIV...
-
Currents induced in motor components from the movement of magnetic fields. Eddy currents produce waste heat and are minimized by laminati...
-
IGBTs (insulated gate bipolar transistor) provide a high switching speed necessary for PWM inverter operation. IGBTs are capable of switc...
0 comments:
Post a Comment